Filter
Top Products
Introduction
3
ENGLISH
READ THIS BEFORE OPERATING YOUR UNIT
Units shipped to the U.S.A. and Canada are
designed for operation on 120 V AC only.
Safety precaution with use of a polarized AC plug.
However, some products may be supplied with a
nonpolarized plug.
CAUTION : To prevent electric shock, match wide
blade of plug to wide slot, fully insert.
ATTENTION : Pour eviter les choc electriques,
introduire la lame la plug large de la borne
correspondante de la prise et poussre jusqu’au
fond.
FOR U.S.A. AND CANADA 120 V
Units shipped to Australia are designed for
operation on 240 V AC only.
To ensure safe operation, the three-pin plug
supplied must be inserted only into a standard
three-pin power point which is effectively earthed
through the normal household wiring. Extension
cords used with the equipment must be three-core
and be correctly wired to provide connection to
earth. Improper extension cords are a major cause
of fatalities.
The fact that the equipment operates satisfactorily
does not imply that the power point is earthed and
that the installation is completely safe. For your
safety, if in any doubt about the effective earthing
of the power point, consult a qualified electrician.
PAN-EUROPEAN UNIFIED VOLTAGE
All units are suitable for use on supplies 230 - 240 V
AC.
FOR EUROPE AND AUSTRALIA 230 V/240 V
FOR YOUR SAFETY
FOR YOUR SAFETY
Units shipped to countries other than the above
countries are equipped with an AC voltage selector
switch on the rear panel. Refer to the following
paragraph for the proper setting of this switch.
AC VOLTAGE SELECTION
This unit operates on 110 - 220 V AC. The AC
voltage selector switch on the rear panel is set to
the voltage that prevails in the area to which the
unit is shipped.
Before connecting the power cord to your AC outlet,
make sure that the setting position of this switch
matches your line voltage. If not, it must be set to
your voltage in accordance with the following
direction.
FOR OTHER COUNTRIES 110 V/ 220 V
FOR YOUR SAFETY
AC voltage selector switch
Move switch lever to match your line voltage
with a small screwdriver or other pointed tool.
AC 110 V
AC 220 V