Filter
Top Products
6
CD
PLAY
ANTENNA
AC INPUT
120V~60Hz
2.1A
MODEL NO. RVD-6090R
AUDIO/VIDEO RECEIVER
FRONT
SWITCHED
120V~60Hz
100W 1A MAX
AC OUTLET
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)this device must accept any interference received,
including interference that may cause undesired operation.
SER. NO
C
E85649
29Z3
LISTED
AUDIO EQUIPMENT
R R
WARNING:"SHOCK HAZARD-DO NOT OPEN"
AVIS:"RISQUE DE CHOC-ELECTRIQUE-NE PAS
OUVRIR"
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
MADE IN KOREA
DESIGNED IN USA
Manufactured under license from Dolby Laboratories. "Dolby",
"PRO LOGIC" and the double-D symbol are trademarks of Dolby
Laboratories. Confidential Unpublished Works. ©1992-1997 Dolby
Laboratories, Inc. All rights reserved.
SUB
WOOFER
SUB
WOOFER
PRE
OUT
CENTER
REAR
LR
FRONT
REAR
CENTER
6-CH
DIRECT
INPUT
REC
AUX
DVD/
TV
IN
OUT
VIDEO
MON.
OUT
VIDEO L R
VCR1
TAPE MON.
DIGI-LINK
CENTER SPEAKER(8Ω)
FRONT
SPEAKERS
(8Ω)
REAR
SPEAKERS
(8Ω)
L
L
R
R
DIGITAL
INPUTS
COAXIAL
AC
-
3/PCM
OPTICAL
■
SWITCHED AC OUTLET
●
This outlet is switched on(power on mode) and
off(standby mode) according to power controls as
follows(Maximum total capacity is 1A, 100W):
Standby mode – switched AC outlet off
Power on mode – switched AC outlet on
●
Never short circuit the + and - speaker cords.
●
Be sure to connect speakers firmly and correctly according to the
channel (left and right) and the polarity (+ and -).
●
Be sure to use the speakers with the impedance of over 8 Ω.
●
For installing the speakers, refer to "Speaker placement" on page 14.
■ CONNECTING SPEAKERS
Front right Front left
Rear
right
CD player
Tape deck
Graphic equalizer
■ CONNECTING SYSTEM CONTROL
●
Connect this jack to the DIGI LINK jack of the
external Sherwood component that uses the DIGI
LINK II or III remote control system.
DIGI-LINK
System
control
cord
Sherwood component
with DIGI LINK II or III
●
Use these jacks when adding additional amplifiers.
●
Connect the PRE OUT jacks to the powered speakers or the
power amplifiers connected to speakers respectively.
●
To emphasize deep bass sounds, connect a powered
subwoofer.
Front speakers
Power amplifier
Rear speakers
Power amplifier
Center speaker
Powered subwoofer
FRONT
SUB
WOOFER
PRE
OUT
CENTER
REAR
■ PRE OUT connections
Power amplifier
■ CONNECTING DIGITAL INPUTS
●
The COAXIAL or the OPTICAL DIGITAL OUTs of
the components that are connected to "CD", "VCR2"
and "DVD/TV" of this unit can be connected to these
DIGITAL INPUTS.
●
A digital input should be connected to the components
such as LD player, CD player or DVD, etc. capable of
outputing Dolby Digital(AC-3) or PCM format digital
signals.
●
For details, refer to the operating instructions of the
component connected.
●
When making the COAXIAL DIGITAL connection,
be sure to use a 75Ω COAXIAL cord, not a
conventional AUDIO cord.
Center
Rear
left
■
AC INPUT CORD
Plug this cord into a wall AC
outlet.
DIGITAL
INPUTS
COAXIAL
AC
-
3/PCM
OPTICAL
Component with
COAXIAL DIGITAL OUT
Component with
OPTICAL DIGITAL OUT
CENTER SPEAKER(8Ω)
FRONT
SPEAKERS
(8Ω)
REAR
SPEAKERS
(8Ω)
L
L
R
R
FM
75Ω
AM
LOOP
EENNGGLLIISSHH