Filter
Top Products
SOUND CONTROL
Volume
Adjust the overall volume with MASTER VOLUME.
Balance
Press BALANCE.
–
BAL
lights up.
Adjust the stereo balance between the left and the right
channel with the VOLUME/TONE/BALANCE control.
Treble
Press TREBLE.
–
TRE
lights up, together with the setting level.
Adjust the high tones from MIN to MAX with the
VOLUME/TONE/BALANCE control.
Bass
Press BASS.
–
BASS
lights up, together with the setting level.
Adjust the bass tones from MIN to MAX with the
VOLUME/TONE/BALANCE control.
WARNING : Extreme settings at high volume may
damage your speakers!.
Use SURROUND MODE to select the desired sound
effect: PRO LOGIC, 3 STEREO
Press MUTE on the remote control if you want to silence
the speakers temporarily.
Press again to restore the same listening level as before.
INPUT SELECTION
Select the desired input on the receiver or the remote
control.
– The selected input will appear on the display.
– When the TAPE MONITOR button is set to on so that
"TAPE M" indicator lights up, other inputs can not be
heard from the speakers.
To listen to a input other than TAPE MONITOR, be sure
to set the TAPE MONITOR button to off.
TAPE MONITOR function
You can connect either a cassette deck or a graphic
equalizer to the receiver's TAPE MONITOR jacks. Only
when you listen to the component to these jacks, set the
TAPE MONITOR button to on.
If you connect a 3–head cassette deck, you can listen to the
sound being recorded during recording, not the source
sound.
For further details, refer to the operating instructions of the
component connected.
SOURROUND MODE
With SURROUND MODE, you can select 2 different
surround modes: PRO LOGIC, 3 STEREO, OFF.
DOLBY PRO LOGIC : choose this setting to play back
movies and music (especially Laser Discs, video cassettes
and TV broadcasts with DOLBY SURROUND sound). Not
only does Dolby Pro Logic surround provide you with sound,
it also gives you a clear perception of the position and
direction of the sound. Make sure your 'Speaker
Positioning' is correct. (see 'INSTALLATION')
With a great number of recently made movies, the sound
track is specially encoded with the Dolby Surround mode
carrying the DOLBY STEREO or DOLBY
SURROUND trademark. The front speakers provide the
dialogue and the normal stereo effect, while the rear
speakers reproduce the surround signals. This position
provides excellent results when watching television
programs, video software, video discs or video tapes of
stereo television broadcasts encoded with Dolby Surround.
Note : In DOLBY PRO LOGIC mode, the rear speakers are
used as "EFFECT SPEAKERS" and may not produce
sound at all times.
AMPLIFIER
8
ENGLISH
POWER ON/OFF
Press the POWER switch to turn the power on.
– The receiver enters the operating mode and the respective indicators lights up.
To turn the power off, press the POWER switch again.
– The power is cut off and the respective indicators lights off.
POWER STANDBY/ON
In the operating mode, press the POWER button on the remote control.
– The receiver enters the standby mode, the respective indicators light off and the standby indicator lights up.
In the standby mode, the receiver is not disconnected from the AC mains and a small amount of current is retained to
support the memorized contents and operation readiness.
– If the electricity fails or the AC cord is leaved unplugged for more than 2 weeks(power off mode), the memorized
contents are all cleared.
In the standby mode, press the POWER button on the remote control.
– The power is turned on, the respective indicators light up and the standby indictor lights off.