Filter
Top Products
TUNER
TUNING
AUTOMATIC TUNING
Press MODE to switch off CH Indicator.
Press TUNING/PRESET or for more than 1
second.
– AUTO appears on the display. The tuner will now search
until a station of sufficient strength has been found. The
display shows the tuned frequency.
If the station found is not the desired one, simply repeat
this operation.
– Weak stations are skipped during automatic tuning.
They can be tuned to manually.
MANUAL TUNING
Manual tuning is useful when you already know the
frequency of the desired transmitter (e.g. from your program
guide).
Press MODE to switch off the PRESET mode.
Briefly press TUNING/PRESET or until the right
frequency has been reached
Tuning intervals:
PRESET STATIONS
You can store 30 preferred stations in the memory of the
tuner. This enables you to find your favorite stations quickly
and easily.
PROGRAMMING OF PRESET STATIONS
Tune either automatically or manually to the frequency to
be stored (as described under TUNING).
– If the display shows no preset number, the frequency
shown has not yet been stored in the memory.
Press MEMORY to enter the frequency in memory.
– MEMO starts flashing for about 5 seconds.
Select the preset number using TUNING/PRESET
or within the time the MEMO indication flashes.
Press MEMORY again.
– The preset station has now been stored in the memory.
A stored frequency is erased from the memory by storing
another frequency in its place.
TUNING TO PRESET STATIONS
Press MODE to switch on the CH indicator.
Select the desired preset number with TUNING/PRESET
or
– The selected station will be tuned in and the display will
show the preset number and the tuned frequency.
With the digit buttons on the remote control
Enter the preset number you have already stored in the
memory with the digit buttons on the remote control.
– The tuner selects the frequncy of the preset number and
the station becomes audible.
– The tuner will return to the previous frequency if other
buttons are pressed.
10
GENERAL
Select the waveband by pressing the FM or the AM button
Tune to a radio station or select a preset number.
The correct procedure is described in the following chapters.
– While tuning, the audio signal will be muted to eliminate interfering background noises.
Once a station is found, the audio signal will be set to normal volume again.
– When STEREO appears on the display, you are receiving an FM stereo transmission.
A disturbing noise, due to a weak FM stereo signal, can be suppressed by pressing FM MODE on the remote control.
– STEREO will disappear on the display and you will hear the FM program in mono.
BAND USA/CANADA EUROPE/AUSTRALIA
FM 200 kHz 50 kHz
AM 10 kHz 9 kHz
ENGLISH