Filter
Top Products
ENGLISH
• After you have installed this unit and connected all the components, you first perform the speaker setup settings for the optimum
sound acoustics according to your environment and speaker layout.
• Even when you change speakers, speaker positions, or the layout of your listening environment, you should perform the speaker
setup settings, too.
• When performing the AUTO SPEAKER SETUP procedure, you need not perform the SPEAKER CONFIGURATION, SPEAKER
DISTANCE and CH LEVEL SETUP procedures.
SPEAKER SETUP
RETURN:Back ENTER:Select
, :Move
SPEAKER CONFIGURATION
SPEAKER DI STANCE
VIRTUAL SPEAKER SETUP
SUBWOOFER : ACT I VE
SUBWOOFER MODE : LFE
CROSSOVER FREQ. : 80Hz
AUTO SPEAKER SETUP
To select the sizes of the speakers that are connected.
To enter the distance between the listening position and each speaker to set
the delay time automatically for the optimum surround playback.
To adjust the Dolby Virtual Speaker setting modes as desired.
To select the type of the subwoofer that is connected.
To select the desired subwoofer mode.
To select the desired crossover frequency.
To set the speaker setup and channel level setup automatically.
SETTING THE SPEAKER SETUP
45
• You can assign the power amplifier for the surround back channels to the ROOM 2.
In this case, you need not use the power amplifier to drive the speakers additionally in a different room (ROOM 2).
STANDBY
POWER ON
MAIN
P
A
G
E
FAV
MUTE
CH.
SET
VOL
RETURN
DISP
MI
OSD/MENU
1
STEREO
CH/
ADJUST
2
3
4
5
6
7
8
9
0
ENT
M2
M3
DSP
DECODE
DSP
RNC-510
RETURN :Back , :Select
POWER AMP ASSIGN
S/BACK
ROOM2
SETTING THE POWER AMP ASSIGN
• Each time these buttons are pressed, the power amplifier is
assigned as follows :
S /BACK : Select this to use power amplifier for the surround back
channels.
ROOM 2 : Select this to use it for the ROOM 2.
Press the CURSOR LEFT( )/RIGHT( ) buttons to use the power amplifier as desired.
STANDBY
POWER ON
MAIN
PAGE
FAV
MUTE
CH.
SET
VOL
RETURN
DISP
MI
OSD/MENU
1
STEREO
CH/
ADJUST
2
3
4
5
6
7
8
9
0
ENT
M2
M3
DSP
DECODE
DSP
RNC-510
SPEAKER CONFIGURATION
SUBWOOFER :
FRONT :
CENTER :
SURR . A/ B : A+B
SURR . (A) :
SURR . (B) :
S/B CH :
SURR . BACK :
RETURN:Back , :Select
Large
Large
Large
Large
Large
Yes
2CH
Press the CURSOR UP( )/DOWN( ) buttons to select the SPEAKER CONFIGURATION, then press
the ENTER button.
1
When selecting the SPEAKER CONFIGURATION