Filter
Top Products
13
ENGLISH
10. CONNECTING MULTI-ROOM SYSTEM KIT
• The multi-room system kit(sold separately ) is essential for operation from a remote location .
For information on the multi-room system kit, contact the Xantech corporation at 1-800-843-5465 or www.xantech.com.
• IR IN jack allow you to control this receiver from another room with the remote control unit.
• To control this receiver from another room with the remote control unit, connect the IR IN jack to the output of the connecting
block.
• If this receiver is located inside a cabinet or other enclosure where the infrared beams from the remote control unit cannot
enter, then operation with the remote control unit will not be possible. In such a case, connect the IR IN jack to the output of
the connecting block.
• To control other compatible component from another room with the universal remote control unit, connect the IR OUT jack to
the IR emitter.
Note:
• Remote operation may become unreliable if the IR receiver is exposed to strong light such as direct sunlight or inverted fluorescent.
Connecting block
(Multi-room system kit)
output
Another room(Room 2)
This receiver
Main room
DVD player
In the cabinet
MULMULTI CONTROLTI CONTROL
MASTER VOLUMEMASTER VOLUME
POWER
STANDBY DECODING STEREO DIGITAL/ANALOGPURE AUDIO VIDEO AUDIO T.MON 8CH DIRECT
ON/OFF
INPUT SELECTOR
IR receiver
(Multi-room system kit)
Connecting block
(Multi-room system kit)
output
This receiver
MULMULTI CONTROLTI CONTROL
MASTER VOLUMEMASTER VOLUME
POWER
STANDBY DECODING STEREO DIGITAL/ANALOGPURE AUDIO VIDEO AUDIO T.MON 8CH DIRECT
ON/OFF
INPUT SELECTOR
IR receiver
(Multi-room system kit)
IR emitter
(Multi-room system kit)
RNC-500
• When this receiver is located inside a cabinet.
VIDEO 6
ROOM2
PHONO TUNERCD
AUX
VIDEO 1 VIDEO 3VIDEO 2
VOLUME
MUTE
VIDEO 4VIDEO 5
VIDEO
AUDIO
Microphone
11. CONNECTING MICROPHONE
• To use Auto Speaker Setup function, connect the supplied
microphone to the SETUP MIC jack.(For details, refer to
“When selecting the AUTO SPEAKER SETUP” on page
51.)
Notes:
• Because the microphone for Auto Speaker Setup is
designed for use with this receiver, do not use a
microphone other than the one supplied with this receiver.
• After you have completed the auto speaker setup
procedure, disconnect the microphone.