Filter
Top Products
SOUND CONTROL
Volume
Adjust the overall volume with the MASTER VOLUME
control.
Balance
Adjust the stereo balance between the left and the right
channels with the BALANCE control.
Treble
Adjust the high tones with the TREBLE control.
Bass
Adjust the bass tones with the BASS control.
WARNING : Extreme settings at high volume may
damage your speakers!
Use SURROUND MODE to select the desired sound
effect: PRO LOGIC, 3 STEREO, STADIUM,
THEATER or HALL.
Press MUTE on the remote control if you want to silence
the speakers temporarily.
The volume indicater blinks.
Press again to restore the same listening level as before.
INPUT SELECTION
Select the desired input on the receiver or the remote
control.
– The selected input will appear on the display.
– Each time INPUT SELECTOR is rotated, the input is
selected as follows;
– When the TAPE 2 MONITOR button is set to on so that
"TAPE 2M" indicator lights up, other inputs can not be
heard from the speakers.
To listen to a input other than TAPE 2 MONITOR, be
sure to set the TAPE 2 MONITOR button to off.
TAPE 2 MONITOR function
You can connect either a cassette deck or a graphic
equalizer to the receiver's TAPE 2 MONITOR jacks.
Only when you listen to the component to these jacks, set
the TAPE 2 MONITOR button to on.
If you connect a 3–head cassette deck, you can listen to the
sound being recorded during recording not the source
sound.
For further details, refer to the operating instructions of the
component connected.
SOURROUND MODE
With the SURROUND MODE button, you can select 5
different surround modes: PRO LOGIC, 3
STEREO, THEATER, HALL, STADIUM, OFF.
DOLBY PRO LOGIC : choose this setting to play back
movies and music (especially Laser Discs, video cassettes
and TV broadcasts with DOLBY SURROUND sound). Not
only does Dolby Pro Logic surround provide you with sound,
it also gives you a clear perception of the position and
direction of the sound. Make sure your 'Speaker Positioning'
is correct. (see 'INSTALLATION')
With a great number of recently made movies, the sound
track is specially encoded with the Dolby Surround mode
carrying the DOLBY STEREO or DOLBY
SURROUND trademark. The front speakers provide the
dialogue and the normal stereo effect, while the rear
speakers reproduce the surround signals. This position
provides excellent results when watching television
programs, video software, video discs or video tapes of
stereo television broadcasts encoded with Dolby Surround.
Note : In DOLBY PRO LOGIC mode, the rear speakers are
used as "EFFECT SPEAKERS" and may not
produce sound at all times.
AMPLIFIER
POWER ON/STANDBY
Press the POWER button on the receiver or the remote control to turn the power on.
– The receiver enters the operating mode, the respective indicators light up and the standby indicator lights off.
To switch the receiver off, press the POWER button again.
– The receiver enters the standby mode and the standby indicator lights up.
In the standby mode, the receiver is not disconnected from the AC mains and a small amount of current is retained to
support the memorized contents and operation readiness.
– If the electricity fails or the AC cord is leaved unplugged for more than 2 weeks, the memorized contents are all cleared.
System power on/off using the remote control.
If the power switch of the component connected by the DIGI LINK
II
or
III
is kept pushed and its AC cord is plugged in
the SWITCHED OUTLETS, each time the POWER button on the remote control is pressed, its power is turned on or off.
Under the same conditions, if its AC cord is not plugged only in the SWITCHED OUTLETS, when the receiver becomes
the standby mode, only its display is off.
8
ENGLISH
TUNER CD AUX TAPE 1 LD
VCR1 VCR2 PHONO