Filter
Top Products
SLEEP
The sleep mode allows the system to continue to operate for
a specified period of time before automatically shutting off.
Press the SLEEP button.
– The display shows the indication SLEEP 10.
– This means that the system will be switched to standby
after 10 minutes.
– Each time the button is pressed, the setting is changed as
below.
Notes:
– During an active sleep timer period, you can reset the
SLEEP time again by pressing the SLEEP button.
– A sleep timer period will be cancelled when you switch
your system to standby (using the POWER button on your
remote control).
RECORDING WITH A CASSETTE DECK
Select the desired input to be recorded.
Start recording on the cassette deck connected to TAPE
MONITOR.
Start play on the desired input.
– For tape monitor function, refer to amplifier titled "TAPE
MONITOR function".
DUBBING FROM VCR2 TO VCR1
Select VCR2 as program source to be recorded.
Start recording on the VCR connected to VCR1.
Start playback on the VCR connected to VCR2.
– For tape monitor function, refer to amplifier titled "TAPE
MONITOR function".
When dubbing from VCR2 to VCR1, you can replace the
audio signal from VCR2 with the signal from an audio
source, e.g. a CD player.
First select VCR2 as program source to be recorded.
Then select the required audio source.
Start recording on the VCR connected to VCR1.
Start playing back on the selected audio source and on
the VCR connected to VCR2.
– You can now watch the picture from VCR2 on your TV
and listen to the sound from the audio source while
recording.
Notes:
– Design and specifications subject to change without
notice for improvement.
MAINTENANCE
Do not leave the unit in direct sunlight or other places
where high temperatures can occur for any length of time,
such as in the vicinity of a heating source.
Do not expose the equipment to humidity or rain.
A chamois leather cloth, slightly moistened with water is
sufficient for cleaning the cabinet.
Do not use cleaning agents containing alcohol, spirits,
ammonia or abrasive.
MODEL
POWER AMPLIFIER SECTION
POWER OUTPUT (8 Ohms)
STEREO MODE (20Hz-20kHz)
THD
IM DISTORTION
POWER OUTPUT (8 Ohms)
SURROUND MODE (LEFT, CENTER, RIGHT)
REAR
PREAMPLIFIER SECTION
INPUT SENSITIVITY/IMPADANCE
PHONO (47K Ohms)
LINE (CD, TAPE, VIDEO, @ 47K Ohms))
SIGNAL TO NOISE RATIO
PHONO
LINE (CD,TAPE,VIDEO)
TONE CONTROLS
BASS (100Hz)
TREBLE (10kHz)
CINEMA BASS
BASS @ 80Hz LEFT /RIGHT, CENTER
FREQUENCY RESPONSE
PHONO (20Hz-20kHz,RIAA)
LINE (CD, TAPE, VIDEO, 10Hz-100Hz)
FM TUNER SECTION
USABLE SENSITIVITY (MONO)
50dB QUIETING SENSITIVITY
MONO
STEREO
SIGNAL TO NOISE RATIO 65dBf,MONO/STEREO
THD @ 65dBf, 1kHz, MONO/STEREO
FREQUENCY RESPONSE (30Hz-15Hz)
STEREO SEPARATION (1kHz)
CAPTURE RATIO
ALTERNATE CHANNEL SENSITIVITY ( @ 98MHZ, +/-400Hz)
IMAGE REJECTION RATIO
IF REJECTIOR RATIO
SPURIOUS REJECTION RATIO
AM TUNER SECTION
USABLE SENSITIVITY (400u V/m)
SIGNAL TO NOISE RATIO
SELECTIVITY
DIMENSIONS and WEIGHTS (Unit)
HEIGHT (INCHES)
WIDTH (INCHES)
DEPTH (INCHES)
WEIGHT (LBS)
ADDITIONAL INFORMATION
11
ENGLISH
10 min 20 min 30 min 60 min
OFF 90 min
R-325
90W x 2
0.05%
0.05%
80W x 3
80W
2.5mV
150mV
77dB
100dB
+,-10dB
+,-10dB
+,-0.5dB
+0,-1.5dB
10.5dBf
15dBf
36.2dBf
80dB/73dB
0.15%/0.25%
+,-1dB
50dB
1.25dB
70dB
80dB
120dB
70dB
12.5uV
50dB
30dB
5 5/8
17 3/8
11 7/8