Filter
Top Products
TUNER
TUNING
AUTOMATIC TUNING
Press TUNING (/for more than 1 second.
– AUTO appears on the display. The tuner will now search
until a station of sufficient strength has been found. The
display shows the tuned frequency.
If the station found is not the desired one, simply repeat
this operation.
– Weak stations are skipped during automatic tuning.
They can be tuned manually.
MANUAL TUNING
Manual tuning is useful when you already know the
frequency of the desired transmitter (e.g. from your program
guide).
Briefly press TUNING (/until the right frequency
has been reached
Tuning intervals ;
FREQUENCY DIRECT INPUT
Select the desired band(FM or AM).
Press DIRECT button.
Press the corresponding digit buttons within 5 seconds
for each step.
– Refer to wave range and step for each band.
Example) FM 89.15 MHz
Select FM.
Press DIRECT button.
Press button "8" within 5 seconds.
Press button "9" within 5 seconds.
Press button "1" within 5 seconds.
Press button "5" within 5 seconds.
PRESET STATIONS
You can store 30 preferred stations in the memory of the
tuner. This enables you to find your favorite stations quickly
and easily.
Programming of preset stations
Tune to the frequency to be stored(as described under
TUNING)
– If the display shows no preset number, the frequency
shown has not yet been stored in the memory.
Press MEMORY to enter the frequency in memory.
– MEM starts flashing for about 5 seconds and PRESET
lights up.
Press the desired number from 1 to 30 while MEM is
flashing.
– The preset station has now been stored in the memory.
A stored frequency is erased from the memory by storing
another frequency in its place.
TUNING TO PRESET STATIONS
Select the desired preset number by pressing digit
buttons.
– The selected station will be tuned in and it will display the
preset number and the tuned frequency.
10
ENGLISH
GENERAL
Select the waveband by pressing the BAND button.
Tune to a radio station or select a preset number.
The correct procedure is described in the following chapters.
– While tuning, the audio signal will be muted to eliminate interfering background noises.
Once a station is found, the audio signal will be set to normal volume again.
– When ST appears on the display, you are receiving an FM stereo transmission.
A disturbing noise, due to a weak FM stereo signal, can be suppressed by pressing FM MODE.
– ST will disappear on the display and you will hear the FM program in mono.
BAND USA/CANADA EUROPE/AUSTRALIA
FM 200 KHz 50 KHz
AM 10 KHz 9 KHz
ENGLISH