Filter
Top Products
3
BEFORE USE C O N N E C T I O N S
S P E C I F I C A T I O N S
P L A C E M E N T
M A I N T E N A N C E
Check following parts included in the package with
the main unit:
1) Turntable platter
2) Slip mat
3) Dust cover
4) 45-rpm adaptor
5) Counterweight
6) Headshell
7) Operating instructions
*Notes:
1) Do not connect the AC power plug before
assembly has been completed.
2) Before turn on the power, check that the voltage
settings is correct.
3) Read this manual carefully before using the unit
and be sure to store the manual in a safe place for
future reference.
1. Connect the power cord to the auxiliary power
outlet on the rear panel of your amplifier or
receiver or to a household AC outlet.
2. Connect the unit output terminals to the PHONO
jack of your amplifier or receiver.
Output terminals Amplifier(Receiver)
L (White) L Channel
R (Red) R Channel
GND (Spade) GND
NOTE:
Be sure to connect the ground terminal firmly to the
amplifier or receiver.
If this connection is not made or is loose, a power
source HUM will result.
General
Power supply
.……….……….....
AC 230V~ 50/60Hz
Power consumption
..…..………................
12 Watts
Dimension(WxDxH)
..…...........
450 x 350 x 145 mm
Weight
...........................…........…..............
9.6 Kgs
For improvement purposes, specifications and design
may be changed without notice.
Do not place the unit in a location where it will be
exposed to direct sunlight or near a heating
appliance.
Do not place the unit in a location where there is
high humidity or a lot of dust.
Cartridge may pick up slight sound pressures or
vibrations from the speakers coming along the
floor or through the air resulting in howling. Find a
location which is very stable and vibration free.
The legs have functions for adjusting the height of
the unit itself. Adjust the legs to stabilize the main
body horizontally.
Clean the stylus periodically with a soft brush to
prevent the accumulation of dust.
When the sound becomes distorted or noisy,
check the stylus. If worn out, replace it with a new
one.
From time to time,the dust cover and turntable
cabinet should be wiped with a soft,dry cloth.
Any volatile materials such as alcohol, thinner,
benzine, ect., may remove the paint or damage
the lustre and should not be used.