Filter
Top Products
2012/ October/ 17
12_XL-UR14H_OM_EN.fm
E-5
Remote control
Caution:
● Replace all old batteries with new ones at the same
time.
● Do not mix old and new batteries.
● Remove the batteries if the unit will not be used for a
long period of time. This will prevent potential damage
due to battery leakage.
● Do not use rechargeable batteries (nickel-cadmium
battery, etc.).
● Installing the batteries incorrectly may cause the unit to
malfunction.
● Batteries (battery pack or batteries installed) shall not
be exposed to excessive heat such as sunshine, fire or
the like.
Notes concerning use:
● Replace the batteries if the operating distance is
reduced or if the operation becomes erratic. Purchase
2 “AAA” size batteries (UM/SUM-4, R03, HP-16 or
similar).
● Periodically clean the transmitter on the remote control
and the sensor on the unit with a soft cloth.
● Exposing the sensor on the unit to strong light may
interfere with operation. Change the lighting or the
direction of the unit if this occurs.
● Keep the remote control away from moisture, heat,
shock, and vibrations.
Check the remote control after checking all the
connections. Point the remote control directly at the remote
sensor on the unit. The remote control can be used within
the range shown below:
General control
Press the ON/STAND-BY button to turn the power on.
● If you turn off and on the main unit with volume set to
16 or higher, the volume will start at 16.
● If you turn the unit off then on again with the volume
level set to less than 16, it will turn on again at the level
set.
Turn the volume knob towards VOLUME +/– (on main unit)
or press VOL +/– (on remote control) to increase or
decrease the volume.
■ Battery installation
1
Open the battery cover.
2
Insert the batteries according to the direction indicated
in the battery compartment.
When inserting or removing the batteries, push them
towards the (–) battery terminals.
3
Close the cover.
■ Test of the remote control
XL-UR14
0.2 m - 6 m
(8" - 20' )
Remote
sensor
■ To turn the power on
After use:
Press the ON/STAND-BY button to enter the power stand-
by mode.
■ Volume auto set-in
■ Volume control
XL-UR14
VOLUME
ON/STAND-BY