Sharp XL-1200 Stereo System User Manual


 
01/2/19 XL-1200(U)3.fm
28
Advanced Features
- Enhancing Your System -
Enhancing Your System
The connection cord is not included. Purchase a commercially avail-
able cord as shown below.
Listening to the playback sounds from
VCR, DVD, etc.
Note:
To prevent hum interference, place this unit away from a television.
To record CD signals on MDs
The digital signal from this unit can be recorded by MiniDisc record-
ers, etc.
Note:
Only CD signals can be output.
Headphones
z
Before plugging in or unplugging the headphones, reduce the vol-
ume.
z
Be sure your headphones have a 1/8" (3.5 mm) diameter plug
and are between 16 ohms and 50 ohms impedance. The recom-
mended impedance is 32 ohms.
z
Plugging in the headphones disconnects the speakers automati-
cally. Adjust the volume using the VOLUME buttons.
VCR, DVD, etc.
MD recorder
Connection cable
for digital recording
White
White
Red
Red
To the line
output jacks
To the optical line
input jack
Headphones
RCA cord
(not supplied)
1 Use a connection cord to connect the VCR, DVD, etc. to the VID-
EO/AUX IN jacks.
When using video equipment, connect the audio output to this
unit and the video output to a television.
2 Press the POWER button to turn the power on.
3 Press the FUNCTION button until "AUX" appears on the display.
When operating with the remote control, press the VIDEO/AUX
button.
4 Play the VCR, DVD, etc.
1 Remove the DIGITAL OUT jack cover.
2 Use a connection cable for digital recording to connect the unit to
the OPTICAL IN jack of a MiniDisc recorder, etc.
3 Press the POWER button to turn the power on.
4 Put the MiniDisc recorder, etc. in the recording mode.
5 Play a CD on this unit.