Filter
Top Products
-30
1 Click “Start” – “All Programs” –
“Accessories” – “Communica-
tions” – “HyperTerminal”.
• If you do not have HyperTerminal in-
stalled, see the operation manual of your
computer.
• Depending on the settings of your com-
puter, you may be required to enter your
area code and other details. Enter the
information as required.
2 Enter a name in the “Name” field,
and click “OK”.
3 If you are required to enter the
area code, enter it in the “Area
code” field. From the “Connect
using” drop-down menu, select
“TCP/IP (Winsock)”, and click
“OK”.
4 Enter the IP address of the pro-
jector in the “Host address” field
(see “TCP/IP” on the “Network”
menu of the projector), and en-
ter the data port of the projector
in the “Port number” field
(“10002” is the factory default
setting), and click “OK”.
Resetting the Lamp Timer of the Projector via LAN
When the projector is connected to a network, you can use HyperTerminal or a similar com-
munications program to send a command to reset the lamp timer. The example below uses
Windows
®
XP as the operating system.
Select
“TCP/IP (Winsock)”