Filter
Top Products
-17
Controlling the Projector via LAN
Setting and Adjusting the
Projector
(Settings & Adjustments)
Example: “Picture” screen display for COMPUTER
On these screens, you can make projector
settings or adjustments. You can set or adjust
the following items :
••
••
• Picture Mode
••
••
• CLR Temp
••
••
• BrilliantColor
TM
••
••
• Progressive (Video)
••
••
• Lamp Setting
••
••
• Resolution Setting
••
••
• Signal Type (Computer, DVI)
••
••
• Dynamic Range (DVI)
••
••
• Video System (Video)
••
••
• Resize
••
••
• Auto Keystone
••
••
• OSD Display
••
••
• Background
••
••
• Setup Guide
••
••
• Projection Mode
••
••
• OSD Language
••
••
• Auto Sync
••
••
• Auto Power Off
••
••
• Auto Restart
••
••
• System Sound
••
••
• Internal Speaker
••
••
• Audio Input
••
••
• RS-232C Speed
••
••
• Fan Mode
••
••
• All Reset
Note
• If you click the “Refresh” button before the
screen is displayed completely, an error mes-
sage (“Server Busy Error”) will be displayed.
Wait for a moment and then operate again.
• You cannot operate this page while the pro-
jector is warming up.
• For details about each item, refer to the
projector’s operation manual.
Setting the Security
(Network – Security)
On this screen, you can make settings relat-
ing to security.
Note
• User Name and Password can be up to 8
characters.
• You can input the characters below :
a-z, A-Z, 0-9, -, _
Description
Setting of user name for
security protection.
Setting of password for
security protection.
It is possible to set up to three
IP addresses allowing connec-
tion to the projector.
No limits are set to IP addresses
connecting to the projector.
For security improvement, only an
IP address set by “Address 1-3”
can be connected to the projector.
Items
User Name
Password
Accept IP
Address
All IP
Addresses
From only
specific IP
addresses