Sharp HTSB250 Speaker User Manual


 
E-3
IMPORTANT SAFETY INSTRUCTIONS (continued)
If the product does not operate
normally by following the operating
instructions. Adjust only those
controls that are covered by the
operating instructions as an improper
adjustment of other controls may
result in damage and will often
require extensive work by a qualied
technician to restore the product to its
normal operation,
If the product has been dropped or
damaged in any way, and
When the product exhibits a distinct
change in performance - this indicates
a need for service.
19) Replacement Parts - When replacement
parts are required, be sure the service
technician has used replacement parts
specied by the manufacturer or have the
same characteristics as the original part.
Unauthorized substitutions may result in
re, electric shock, or other hazards.
20) Safety Check - Upon completion of any
service or repairs to this product, ask the
service technician to perform safety checks
to determine that the product is in proper
operating condition.
21) Wall or ceiling mounting - When mounting
the product on a wall or ceiling, be sure to
install the product according to the method
recommended by the manufacturer.
22) Power Lines - An outside antenna system
should not be located in the vicinity of
overhead power lines or other electric light
or power circuits, or where it can fall into
such power lines or circuits. When installing
an outside antenna system, extreme care
should be taken to keep from touching such
power lines or circuits as contact with them
might be fatal.
d)
e)
f)
23) Protective Attachment Plug - The product is
equipped with an attachment plug having
overload protection. This is a safety feature.
See Instruction Manual for replacement or
resetting of protective device. If replacement
of the plug is required, be sure the service
technician has used a replacement plug
specied by the manufacturer that has the
same overload protection as the original
plug.
24) Stand - Do not place the product on an
unstable cart, stand, tripod or table. Placing
the product on an unstable base can cause
the product to fall, resulting in serious
personal injuries as well as damage to
the product. Use only a cart, stand, tripod,
bracket or table recommended by the
manufacturer or sold with the product. When
mounting the product on a wall, be sure to
follow the manufacturer’s instructions. Use
only the mounting hardware recommended
by the manufacturer.