Filter
Top Products
E-9
Falling prevention
Safety wires (not supplied) are useful to prevent
the unit from falling off the table.
Loop the safety wires (not supplied) into each
hole as shown and tie the safety wires to the
LCD TV stand.
Sound bar connections to TVs
Caution:
Turn off all other equipment before making any
connections.
Tuner receiving for other audio system
Placing the antenna near the unit AC
power cord may cause noise pick up.
Place the antenna away from the unit for
better reception.
●
Notes:
To connect to TV, use either LINE IN 1
jacks or AUDIO LINE IN 2 jack only.
Refer the operation manual of the
equipment to be connected.
Fully insert the plugs to avoid fuzzy
pictures or noises.
●
●
●
Connecting to a TV■
If the TV/monitor has an audio output, connect it
to the LINE IN 1 jacks on the rear of the unit.
TV
To audio output
jacks
RCA cable (supplied)
To LINE IN
1 jacks
Connecting to a TV (with
Headphone jack)
■
If the TV/monitor has headphone jack, connect it to
the LINE IN 2 jack on the rear of the unit.
HEADPHONE
TV
To HEADPHONE
jack
Audio cable
(not supplied)
To AUDIO
LINE IN 2
jack
Sound bar
To select LINE IN 1 function:
● On the unit: Press FUNCTION button repeatedly
until “L1” is displayed.
● On remote control: Press LINE button repeatedly
until “L1” is displayed.
To select LINE IN 2 function:
● On the unit: Press FUNCTION button repeatedly until
“L2” is displayed.
● On remote control: Press LINE button repeatedly until
“L2” is displayed.
Notes:
● If the TV volume is continuously in low level, the unit
will automatically power off. Increase the TV output
volume to enjoy the sound from the unit.
● If the unit volume is continuously in very high level, the
unit will mute and recover after 3 seconds.
Sound bar