Filter
Top Products
E-13
Setup & Connections
1
2 To S-video output terminal
2 To video output terminal
1
Projector
VCR, Laser disc player,
DVD player or DTV decoder
Connecting to Video Equipment
Connecting to a DVD Player and DTV Decoder
2 To component output
terminals
1
Component cable
(commercially available)
DVD player
or
DTV decoder
1 Connect each RCA connector of a component cable to the corresponding
RCA INPUT 1 terminals on the projector.
2 Connect the other end of the cable to the corresponding terminals on a DVD
player or DTV decoder.
CAUTION
• Make sure to turn both the projector and the video equipment off, before switching
the “DIGITAL INPUT TYPE” swich and connecting.
S-video cable (commercially available)
Video cable
Projector
Connecting to a DVD player and DTV decorder with Component output (for INPUT 1)
Connecting to a DVD player and DTV decoder with component output (for INPUT 2)
1 Connect the 3 RCA to 15-pin D-Sub cable using the DVI to 15-pin D-Sub adaptor.
2 Use the above cables to connect the projector and the DTV decoder.
When connecting this projector to analog RGB output of the DTV decoder, select “Component” for “Signal Type” on the
OSD menu or press RGB/COMP. on the remote control. (See page 36.)
CAUTION
• Make sure to turn both the projector and the video equipment off, before switching the “DIGITAL INPUT TYPE” swich and
connecting.
DVI to 15-pin D-sub adaptor
(sold separately AN-A1DV)
Projector
3 RCA to 15-pin D-sub cable
(sold separately AN-C3CP)
DVD player
or
DTV decoder
DT-200(E)#p12_14.p65 02.11.21, 11:30 AM13