Filter
Top Products
35
CD-G10000
CP-G10000S
Tape Recording
Sequential recording from several discs:
To perform programmed recording:
To stop recording:
Press the button.
The disc and tape will stop.
Recording from the radio
To interrupt recording:
Press the button.
To resume recording, press the / button.
To stop recording:
Press the button.
Note:
If you hear a whistling noise while recording an AM station, move
the AM loop antenna.
Dubbing from tape to tape
You can record from TAPE 1 to TAPE 2.
To stop dubbing:
Press the button.
TAPE 1 and TAPE 2 will simultaneously stop.
Erasing recorded tapes
Note:
Make sure that the TAPE 1 is not in use.
1 Perform steps 1 - 5 in "Recording from a CD or MP3 disc" on page
34.
2 Within 5 seconds, press the / button.
1 Program discs and tracks (see pages 25, 29).
2 Press the button.
3 Press the / button.
1
Tune in to the desired station (see page 30).
2
Load a cassette into the TAPE 2 cassette compartment
with the side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3
Press the button.
Recording will be paused.
4
Press the / button to start recording.
1
Press the ON/STAND-BY button to turn the power on.
2
Load a prerecorded cassette
into the TAPE 1 cassette com-
partment. Insert a blank tape
into the TAPE 2 cassette com-
partment.
It is recommended that the recording tape is the same length as
the master tape.
3
Press the TAPE (1 2) button until "TAPE 1" appears on
the display.
4
Press the button.
Recording will be paused.
5
Press the / button to start dubbing.
1 Load the tape to be erased into the TAPE 2 cassette compart-
ment with the side to be erased facing toward you.
2 Press the TAPE (1 2) button until "TAPE 2" appears on the dis-
play.
3 Press the button.
4 Press the / button to start erasing.
TAPE 1 TAPE 2