Filter
Top Products
24
Listening to a Cassette Tape (TAPE 1 or TAPE 2)
1 Press the POWER button to turn the power on.
2 Open the cassette door by pushing the area marked “
7 7
7 7
7 PUSH
EJECT”.
3 Load the cassette into the TAPE 1 or TAPE 2
cassette compartment with the side to be
played facing toward you.
4 Press the TAPE (1
VV
VV
V 2) button to select the cassette you want to
listen to.
5
Press the
0/R0/R
0/R0/R
0/R (
0 0
0 0
0 ) button to start playback.
To stop playback:
Press the ■ (TAPE ■) button.
Fast forward/rewind: (TAPE 2 only)
1.
Press the ■ (TAPE ■) button, then press the TAPE (1 V 2) button to select TAPE 2.
2. To advance the tape, press the W PRESET 2 4 ( 2) button.
To rewind it, press the 5 3 PRESET X ( 3 ) button.
Caution:
To remove the cassette, press the ■ (TAPE ■) button, and then open the compart-
ment.
Before changing from one tape operation to another, press the ■ (TAPE ■) button.
If a power failure occurs during tape operation, the tape head will remain engaged
with the tape and the cassette door will not open. Wait until the power is restored.
Before playback:
For playback, use normal or low-noise tape for the best sound.
(Metal or CrO2 tape is not recommended.)
Do not use C-120 tapes or poor-quality tapes, as they may cause
malfunctions.
Before loading a tape into the cassette compartment, tighten the slack
with a pen or pencil.
TAPE 1 TAPE 2
Tape Playback
– Listening to a Cassette Tape (TAPE 1 or TAPE 2) –
Playback is possible in TAPE 1 compartment as well as in TAPE 2.
Sound Control (See page 16.)