Filter
Top Products
22
To receive an FM stereo transmission:
Press the TUNER (BAND) button so that the “ST” indicator lights up.
“j” will appear when an FM broadcast is in stereo.
If the FM reception is weak, press the TUNER (BAND) button so that the “ST” indi-
cator goes out. The reception changes to monaural, and the sound becomes clearer.
After use:
Press the POWER button to enter the power stand-by mode.
Listening to the Radio
1 Press the POWER button to turn the power on.
2 Press the TUNER (BAND) button repeatedly to select the desired
frequency band (FM or AM).
3 Press the TUNING/TIME (
XX
XX
X or
WW
WW
W) button to tune in to the desired
station.
Manual tuning:
Press the TUNING/TIME button as many times as required to tune in to the
desired station.
Auto tuning:
When the TUNING/TIME
button is pressed for more than 0.5 seconds, scan-
ning will start automatically and the tuner will stop at the first receivable broad-
cast station.
Notes:
When radio interference occurs, auto scan tuning may stop automatically at
that point.
Auto scan tuning will skip weak signal stations.
To stop the auto tuning, press the TUNING/TIME
button again.
FM stereo mode indicator
FM stereo receiving indicator
Radio
– Listening to the Radio –
Sound Control (See page 16.)