Filter
Top Products
Using the transmitter
13
Using the transmitter
To establish a transmission link, proceed as follows:
1. Switch the transmitter on (see below).
2. Switch the
EK 2000 IEM
receiver on (see the instruction manual of the receiver).
The transmission link is established.
If you cannot establish a transmission link between transmitter and receiver:
̈ Make sure that transmitter and receiver are set to the same frequency bank and to the
same channel.
̈ If necessary, read the chapter “If a problem occurs ...” on page 24.
Switching the transmitter on/off
To switch the transmitter on (online operation):
To switch the transmitter to standby mode:
̈ If necessary, deactivate the lock mode (see page 14)
To switch the transmitter on and to deactivate the RF signal on switch-on (offline operation):
To completely switch the transmitter off:
̈ Disconnect the transmitter from the mains by unplugging the mains plug from the wall
socket.
The backlighting of the STANDBY button º goes off.
It is vital to observe the notes on frequency selection on page 22.
0**
º
̈ Briefly press the STANDBY button º.
The transmitter switches on and the standard display appears.
The transmitter transmits an RF signal and the transmission icon
ቦ
is displayed.
̈ Keep the STANDBY button º pressed until “OFF” appears on the display panel.
The display panel switches off.
When in the operating menu, pressing the STANDBY button º will cancel your entry
(ESC function) and return you to the standard display.
The STANDBY button º is backlit in red both during operation and in standby mode.
̈ Press the STANDBYbutton º until “RF Mute On?” appears on the display panel.
̈ Press the jog dial.
The transmission frequency is displayed but the transmitter does not transmit an
RF signal. The transmission icon
ቦ
is not displayed
.
Standard -18dB
MHz
PEAK
-10
0
-20
-30
-40
PEAK
-10
0
-20
-30
-40
AF II
AF I
**2000**
552.300
B.Ch: 5.14
EQ
ቦ