Sennheiser S-MCD 3000 HP Stereo Receiver User Manual


 
73
Ǡ Div Src
This bar gives you information on the channel switched on at a certain point in time. Each receiver
has two RF signals which can be recorded and displayed. However, only one signal is switched on
at a certain point in time. This information is displayed in the Diversity bar. The colored sections
indicated the channel active at this point in time. In the “RF Spectrum Analyzer”, these data are not
a function of the point in time but of the frequency in question.
Ǡ Div Mem
This bar has the same function as “Mem Src”, with the one difference that the function stored
temporarily is based on the Diversity information.
Ǡ Marker On/Off
This button allows you to activate the two markers which you can move within the current visible
range of the measuring curve.
Ǡ Zoom In
With active markers, this allows you to zoom in on the range between both limits.
Ǡ Zoom Out
If you have zoomed into the measuring range beforehand, you can reverse this process step by
step.
Ǡ Comment
You can enter a comment on the current input data in this input field. If you then save the measured
data, the comment is also stored. The comment can have a maximum length of 40 characters.
Ǡ Close RF Recorder
You can close the RF recorder using this command.