Filter
Top Products
Adjustment tips for the operating menu
34
Via the “Command” menu, you can determine which of the audio and
command outputs will be switched on and off when the command button
on the transmitter is pressed. There are four configuration options:
The active output lights up in the command display; muted outputs are not
displayed (see “Command display (status display of the audio outputs AF
and Command)” on page 12).
̈ Change to the setting mode of the “Command” menu.
The current configuration starts flashing.
̈ Select one of the four configurations by turning the jog dial 7.
̈ Press the save button 8.
The selected configuration is stored. The display changes to the selec-
tion mode of the operating menu.
Changing to the extended menu
Via the “More” menu, you can change to the extended menu with the
menus “Scan”, “Compander”, “Display”, “IP-Addr”, “MAC”, “Standby” and
“Reset”.
WHEN the “Command”
menu of the receiver is
configured as shown …
…AND the
command button
on the transmitter
is …
… THEN the receiver’s
audio outputs are
switched ...
not pressed
AF Out: on
Command: off
pressed
AF Out: on
Command: on
not pressed
AF Out: on
Command: off
pressed
AF Out: off
Command: on
not pressed
AF Out: on
Command: on
pressed
AF Out: off
Command: on
not pressed
AF Out: on
Command: on
pressed
AF Out: on
Command: on
1
AF
COM
AF
AF
AF
COM
2
AF
COM
AF
COM
3
AF
COM
COM
AF
COM
COM
4
AF
COM
COM
AF
AF
COM
AF
COM
1
AF
COM
AF
esc
save
sync
digital audio
processing
sync
D
EV
M
H
z
777.005
U.01
BANK
CH
COM
AF
HD
P
8
7
If you do not want to use the command function, select the config-
uration “4”.
More
m
mand
3