Filter
Top Products
Product overview
12
Command display (status display of the audio outputs AF and
Command)
The command display is only available with the EM 3732 COM-II twin
receiver.
Besides the two audio outputs K and M the EM 3732 COM-II twin receiver
also features the two command outputs J and L.
Via the “Command” menu, you can configure the receiver so that – with
the command button of the transmitter pressed – the audio signal is avail-
able at only one of the outputs or at both (see “Configuring the audio
outputs of the EM 3732 COM-II” on page 33).
The command display ¾ shows the audio output at which the trans-
mitter’s audio signal is available.
When “AF” lights up brightly, the audio signal is available at the audio
output K and/or M.
When “AF” does not appear, the audio signal is not issued on the audio
output K and/or M.
When “COM” lights up brightly, the audio signal is available at the
command output J and/or L.
When “COM” does not appear, the audio signal is not issued on the
command output J and/or L.
Display for the compander system
Depending on the selected compander system, either “HDP” for
HiDyn
plus
™ or “HDX” is shown on the display.
LEDs for booster supply of antenna inputs
The LEDs for booster supply of antenna input A N and/or B S light up
when:
• the booster supply voltage is applied to the corresponding antenna
input A O and/or B R.
The LEDs for booster supply of antenna input A N and/or B S go off
when:
• the booster supply voltage for the corresponding antenna input A O
and/or B R is switched off or
• the booster supply voltage is short-circuited or overloaded.
COM
AF
JK
LM
AF
COM
HD
X
HD
P
N
OP
Q
R
S