Sennheiser EM 3731-II Home Theater System User Manual


 
17
Putting the receiver into operation
Connecting the receiver to the mains/
disconnecting the receiver from the mains
The receiver has no mains switch. To connect the receiver to the mains:
̈ Connect the supplied mains cable to the 3-pin mains socket D.
̈ Plug the mains connector into the wall socket.
To disconnect the receiver from the mains:
̈ Pull out the mains connector from the wall socket.
All daisy chained signals are interrupted, i.e.:
the antenna signals at the daisy chain outputs Q and P,
the booster supply voltage,
the signal of the external word clock generator.
Connecting the amplifier/mixing console
The receiver has transformer balanced audio outputs.
̈ Connect the amplifier/mixing console to the XLR-3 socket
AF Out 1 M (left receiver) or to the XLR-3 socket AF Out 2 K (right
receiver).
̈ Via the operating menu of the corresponding receiver, adjust the level
of the audio output to the input of the amplifier or mixing console (see
“Adjusting the audio output level” on page 33).
CAUTION! Damage to the device due to electric current!
If you connect the receiver to an unsuitable power supply,
this can cause damage to the device.
̈ Use the supplied mains cable to connect the receiver to
the mains (100 to 240 V AC, 50 or 60 Hz).
̈ Ensure a reliable mains ground connection of the receiver
– especially when you are using multi-outlet power strips
or extension cables.
D
K
M