Sanyo DC-MX30 Stereo System User Manual


 
7
1. Unwind the AC Power Cord completely.
2. Insert the plug into any convenient AC outlet.
3. As soon as the unit has been connected with the mains voltage, parts of the unit are in
operation due to the standby function. Turn off the unit completely before pulling the mains plug
out of the AC outlet.
AUX connection
1. Slide Function selector to AUX.
2. Connect a 3.5mm stereo jack lead to the AUX IN socket and the other end to your preferred
device.
3. Play your device.
BASIC OPERATION
Adjusting the sound volume
Turn the - volume + control to increase or decrease the sound level.
BASSXPANDER button
ON: Press the BASSXPANDER button once to active boost low frequency sound and the
BASSXPANDER indicator will light up.
OFF: Press once during ON mode and BASSXPANDER Indicator goes off.
RADIO OPERATION
1. Connect the power cord.
2. Slide the FUNCTION selector to RADIO position.
3. Slide the BAND selector to select the desired band. (AM/ FM/FM ST)
4. Turn the TUNING button to select the desired band.
5. Adjust + VOLUME – control to a comfortable sound level.
ANTENNA reception tips
FM: Extend and move the FM Antenna Wire. If stereo broadcast is received, the FM STEREO
indicator will light up. In case of Stereo stations with a bad reception (noise infested reception), we
recommend slide BAND selector to MONO position.
AM: This system is equipped with a built-in directional ferrite antenna,
move and rotate the system for best reception.