Samsung VP-D270(I) Stereo Amplifier User Manual


 
ENGLISH
Preparation
2424
Using the Lithium Ion Battery Pack
The amount of continuous recording time available depends on.
- The type and capacity of the battery pack you are using.
- How often the Zoom function is used.
It is recommended that you have several batteries available.
Charging the Lithium Ion Battery Pack
1. Attach the battery pack to the camcorder.
2. Connect the AC Power adapter to an AC
cord and connect the AC cord to a wall
socket.
3. Connect the DC cable to the DC jack
socket on the camcorder.
4. Turn the Camera power switch to off, and
the charging indicator will start to flash,
showing that the battery is charging.
5. When the battery is fully charged, disconnect the
battery pack and the AC Power adapter from the camcorder.
Even with the power switched off, the battery pack will
still discharge if it is left connected to the camcorder.
Notes
The battery pack may be charged a little at the time of purchase.
To prevent reduction in the life and capacity of the battery pack, always
remove it from the camcorder after it is fully charged.
Blinking time Charging rate
Once per second Less than 50%
Twice per second 50% ~ 75%
Three times per second 75% ~ 90%
Blinking stops and stays on 90 ~ 100%
On for a second and Error - Reset the battery pack and
off for a second the DC cable
- .
- Zoom
1.
2.
3.
4.
5.
1 1 50%
1 2 50% ~ 75%
1 3 75% ~ 90%
90% ~ 100%
1 1
TAPE
EJECT
VOL/M
CHARGE
5