Filter
Top Products
6 English English 7
Description
1. FM Antenna Connector Terminal
1.
Connect the FM antenna to the FM antenna con-
nector terminal.
2.
Slowly move the antenna wire until you find a
location where reception is good, then fasten it to
a wall or other rigid surface.
3.
If reception is poor, you may need to install an
outdoor antenna. To do so, connect an outdoor
FM antenna to the FM antenna connector terminal
of the product using a 75Ω coaxial cable (not
supplied).
2. ONLY FOR SERVICE
• This jack is just for testing. Do not use.
3. AUX IN 2 Terminals
1.
Use an Audio Cable (not supplied) to connect AUX
IN 2 on the product to Audio Out on an external
analog output device.
• Be sure to match connector colors.
• If the external analog output device has only one
Audio Out jack, connect either left or right.
• Press the TUNER/AUX button to select the AUX 2.
• If no button actions for more than 8 hours in AUX
mode, the power will automatically turn off.
4. LED Terminals for Speaker Beat Waving.
5. 2.2 CH Speaker Terminals
1.
To achieve the correct sound quality, when you con-
nect the speakers, match the color of the speaker
plugs to the color of the speaker jacks. See below.
• LEFT channel (marked
L
, White/Purple).
• RIGHT channel (marked
R
, Red/Purple).
•
Don't force the Purple SUBWOOFER connector
into the White or Red speaker jack.
6. POWER
• Insert only the provided power cable.
7. Cooling fan
• The fan operates while the unit is powered on.
If you set the unit to the minimum volume, the fan
won't operate.
Provide a minimum of 6 inches (15 cm) of clear
space in front of the fan when you install the
product.
Rear Panel
5421 3
7
6
MX-FS9000-ZA-ENG_130401.indd 6 2013-04-01 �� 11:10:11