Filter
Top Products
22
FUNCTIONS
23
SOFTWARE UPDATE
AUX IN
OPTICAL IN
HDMI IN
HDMI OUT (TV)
Samsung may offer updates for the Soundbar's
system firmware in the future.
If an update is offered, you can update the firmware
by connecting a USB device with the firmware
update stored on it to the USB port on your
Soundbar.
Note that if there are multiple update files, you must
load them onto the USB device singly and use them
to update the firmware one file at a time.
Please visit samsung.com or contact the Samsung
call center to receive more information about
downloading updates files.
● I nsert a USB device containing the
firmware update into the USB port on the
main unit.
● Updating firmware may not work properly
if audio files supported by the Soundbar
are stored in the USB storage device.
● Do not disconnect the power or remove
the USB device while updates are being
applied. The main unit will turn off
automatically after completing the
firmware update.
● After the update, all settings are reset to
their factory default settings. We
recommend you write down your settings
so that you can easily reset them after the
update. Note that updating firmware
resets the subwoofer connection too.
If connection to the subwoofer is not
re-established automatically after the
update, refer to page 14.
If the firmware fails to update, we
recommend formatting the USB device in
FAT16 and trying again.
● Once the software update is completed,
turn off the product and then press and
hold the (
p
) button on the remote
control for more than 5 seconds. “INIT”
appears on the display and the unit is
powered off. The updgrade is complete.
● Do not format the USB device in the NTFS
format. The Soundbar does not support
the NTFS file system.
● Depending on the manufacturer, some
USB devices may not be supported.
AUTO POWER LINK
If you have connected the main unit to a TV with
a digital optical cable, set the Auto Power
function ON to have the Soundbar turn on
automatically when you turn the TV on.
AUTO POWER
LINK
Display
ON
ANYNET+ OFF /
POWER LINK ON
OFF
ANYNET+ ON /
POWER LINK OFF
1. Connect the Soundbar and an External Device
with an Optical cable.
2. Press the
(Function) button on the main
unit’s top panel or the SOURCE button on the
remote control to select the
D.IN
mode.
3. Press the Anynet+ button on the remote
control to toggle the Auto Power Link function
on and off.
● Depending on the connected device,
Auto Power Link may not function.