Filter
Top Products
11
EnG
● COnnECTIOnS
The Subwoofer's linking ID is preset at the factory and the main unit and sub should link (connect wirelessly)
automatically when main unit is turned on. If the link indicator (
STANDBY
LINK
) does not light when main unit and
subwoofer are turned on, please set the ID by following the process below.
Before moving or installing the product, be sure to turn off the power and disconnect the power
cord.
If the main unit is powered off, the wireless subwoofer will be in the standby mode and the
STANDBY LED on the upper side will come on after the Link indicator (Blue LED) blinks for 30
seconds.
If you use a device that uses the same frequency (2.4GHz) near the system, interference may
cause some sound interruption.
The transmission distance of the wireless signal between the main unit and sub is about 33 ft.,
but may vary depending on your operating environment. If a steel-concrete or metallic wall is
between the main unit and the wireless subwoofer, the system may not operate at all, because
the wireless signal cannot penetrate metal.
If the main unit doesn't make a wireless connection, follow steps 1-5 above to retry the
connection between the main unit and wireless subwoofer.
The wireless receiving antenna is built into the wireless subwoofer. Keep the unit away from
water and moisture.
For optimal listening performance, make sure that the area around the wireless subwoofer
location is clear of any obstructions.
▪
▪
▪
▪
▪
▪
▪
Plug the power cords of the main unit and subwoofer into an AC power supply.
Press the button on the back of the subwoofer with a small, pointed object for 5 seconds.
The STANDBY indicator is turned off and the LINK indicator (Blue LED) blinks quickly.
•
STANDBY
LINK
POWER
TV POWER
AH59-02434A
SAT MUTE SMART
VOLUME S/W LEVEL AUDIO SYNC
SAT
SOURCE
SOUND SPEAKER
DIMMER
AUTO POWER
TV INFOTV SOURCE
TV VOL TV VOL
TV CH
TV CH
TV PRE-CH
TV EXIT
DRCREPEAT
3D SOUND
VOLUME
EFFECT
TV
MUTE
POWER
TV POWER
AH59-02434A
SAT MUTE SMART
VOLUME S/W LEVEL AUDIO SYNC
SAT
SOURCE
SOUND SPEAKER
DIMMER
AUTO POWER
TV INFOTV SOURCE
TV VOL TV VOL
TV CH
TV CH
TV PRE-CH
TV EXIT
DRCREPEAT
3D SOUND
VOLUME
EFFECT
TV
MUTE
While the main unit is powered off (
STANDBY
mode),
press on the remote control for 5 seconds.
The message appears on the main unit’s VFD.
To nalize the link, turn the main unit’s power on while the
subwoofer’s Blue LED blinks.
The main unit and the subwoofer are now linked (connected).
The Link indicator (blue LED) on the subwoofer is turned on.
You can enjoy better sound from the wireless subwoofer by
selecting the sound effect. (See page 20)
•
•
•