Filter
Top Products
ENG
CONNECTIONS
1514
Speaker Installation
1 Turn the STAND upside-down and connect it to
the STAND BASE.
2 Turning the screw (A) clockwise, connect it to two holes
marked with the arrow using a screwdriver as shown in
the illustration.
3 Turning the supplied screw (B) clockwise, connect it to a
hole on the rear of the Speaker STAND.
4 Connect the assembled stand to the SPEAKER.
5 Turning the screw (B) clockwise, connect to a hole on
the rear of the speaker using a screwdriver as shown
in the illustration.
6 This is the successfully assembled speaker.
How to Install the Speaker and the Stand
•
Make sure that the speaker is installed on a flat and stable area.
Otherwise it may be easily knocked over.
SPEAKER STAND
STAND BASE
Screw (B)Screw (A)
1
3
4
2
5 6
Component
15
To connect the rear speakers wirelessly, you have to purchase the wireless receiving module and
TX card from your Samsung retailer.
Connecting the Optional Wireless Receiving Amplifier
Front Speaker (R)
Rear Speaker (L)
Subwoofer
Center Speaker
Front Speaker (L)
Rear Speaker (R)
WIRELESS RECEIVER MODULE
Front Speaker (R)
Rear Speaker (L)
Subwoofer
Center Speaker
Front Speaker (L)
Rear Speaker (R)
WIRELESS RECEIVER MODULE
When you have Purchased the Wireless Receiving Module (SWA-3000)
HT-X250
HT-TX250
HT-X250-TX250(1~41P)-NO EUR 2007.3.19 5:50 PM Page 14