Filter
Top Products
ENG
OPERATION
2726
Before Using Your Home Theater
To Operate your Samsung TV and the Home Theater with the HT-X250/HT-TX250's Remote Control
1 Plug the main unit's power cord into the AC power supply.
■
Before plugging your system into a main socket, you must check the voltage setting.
If the voltage of the socket does not correspond to the setting on the rear of the unit,
you may seriously damage your system.
2 Press the TV button to set the remote to TV mode.
3 Press the POWER button to turn on your Samsung TV
with this remote.
4 Press the TV/VIDEO button to select VIDEO mode on your TV.
5 Press the DVD RECEIVER button to switch to DVD RECEIVER mode to
operate the DVD Home Theater
6 Press the FUNCTION button on the main unit or DVD button
on the remote to enable DVD playback.
VIDEO
Disc Playback
1 Load a disc vertically into the Disc Insert Hole.
■
Insert a disc so that the label side faces facing forward.
■
Playback starts automatically.
2 To eject the disc, press the EJECT button.
• Depending on the content of the disc, the initial screen may appear different.
•
Pirated discs will not run in this player because it violates the CSS (Content Scrambling System : a copy protection system)
recommendations.
To stop playback, press the STOP button during playback.
■
If pressed once, <PRESS PLAY> is displayed and the stop position will be stored in memory.
If the PLAY/PAUSE ( ) button or ENTER button is pressed, playback resumes from the stop position.
(This function works only with DVDs.)
■
If pressed twice, <STOP> is displayed, and if the PLAY/PAUSE ( ) button is pressed, playback starts from the
beginning.
To temporarily pause playback, press the PLAY/PAUSE ()button during playback.
■
To resume playback, press the PLAY/PAUSE ( ) button again.
The DVD Home Theater's remote can be used to control Samsung TVs.
ALL
Press and hold the NT/PAL button on the remote controller for over 5 seconds
while the power is turned off.
■
By default, the video format is set to <PAL>.
■
<NTSC> or <PAL> will appear in the display. At this time, press the NT/PAL button shortly to select
between <NTSC> and <PAL>.
■
Each country has a different video format standard.
■
For normal playback, the video format of the disc must be the same as the video format of your TV.
Selecting the Video Format
DVD VCD CD
HT-X250-TX250(1~41P)-NO EUR 2007.3.19 5:50 PM Page 26