Filter
Top Products
English 29
02 Connections
Wireless Network
You can connect to the network with a Wireless IP sharer.
Connect the included wireless LAN adapter to the Wireless LAN jack on the back panel of the
product.
- This unit is compatible with the supplied Wireless LAN Adapter.
- You can also use the wireless network by connecting the Wireless LAN Gender Adapter to the
Wireless LAN Adapter, and then attaching the Wireless LAN Adapter to the Gender Adapter.
Set the network options. (See page 40)
NOTE
You must use a wireless IP sharer that supports IEEE 802.11 a/b/g/n. (n is recommended for stable operation of the
wireless network.)
Wireless LAN, by its nature, may cause interference, depending on the use condition (AP performance, distance, obstacles,
interference by other radio devices, etc).
Set the wireless IP sharer to Infrastructure mode. Ad-hoc mode is not supported.
When applying the security key for the AP (wireless IP sharer), only the following is supported.
Authentication Mode : WEP, WPAPSK, WPA2PSK
Encryption Type : WEP, AES
For the AllShare function, a PC must be connected in the network as shown in the fi gure.
Connecting the FM Antenna
Connect the FM antenna supplied to the FM
Antenna Jack.
Slowly move the antenna wire around until
you fi nd a location where reception is good,
then fasten it to a wall or other rigid surface.
NOTE
This product does not receive AM broadcasts.
1.
2.
✎
1)
2)
1.
2.
✎
iPod
iPod
FM Antenna (supplied)
iPod
Wireless IP sharer
Wireless LAN Adapter
Networking with PC for
AllShare function
(See pages 62~63)
PC
Broadband
service
OR
HT-C7530W_XAA_0817.indd 29HT-C7530W_XAA_0817.indd 29 2010-08-17 8:49:452010-08-17 8:49:45