Filter
Top Products
GB
9
The AM aerial (for long and medium waves) can be:
Placed on a stable surface
Fixed to the wall (you must first remove the base)
The AM aerial connector terminals are located on the rear of the system
and are marked AM .
To avoid noise interference, check that the loudspeaker wires do not
run close to the aerial wires.
Always keep them at least 2 inches (5 cm) away.
Connecting the AM (MW)/LW Aerial
Connecting the FM Aerial
SW ANT.
Connecting the SW Aerial (option)
How to connect a WIRE TYPE aerial.
Spread the SW aerial out and attach the ends to a wall, in the position
providing the best reception.
If reception is poor (e.g. distance from transmitter too great, walls blocking
the radio waves, etc.), install an outdoor aerial.
SW ANT.
There are two types of aerial, (depending on option chosen).
How to connect a SCREW TYPE aerial.
The FM aerial connector terminals are located on the rear of the
system and marked FM (75Ω).
Spread the T.form FM aerial out and attach the ends to a wall,
in the position providing the best reception.
Using the Audio Cord, Connect the Audio Output Terminals (Left, Right)
of the System with the Audio Input Terminals (Left, Right) of the Video
Input Cassette Recorder, so as to Record VCD.
Using the Video Cord, Connect the Video Output Terminal of the system
with the Video Input Terminal of TV.
Turn on the TV and Select the Video mode by pressing the TV/VIDEO
SELECT button to the VIDEO Position.
Please Pay Attention not to Connect the Audio Output Terminals (left,
right) of the System with the Audio Input Terminal of TV.
Connecting to the Equipment
SW ANT
AMPLIFIER
AUDIO INPUT
VIDEO INPUT
RL
TV
MAX-VL45GB-1~18 11/12/02 1:43 PM Page 9