Filter
Top Products
AUX RET 2
The AUX RETURN 2 adjusts the level of the signal present at the AUX 2 RET jacks. This signal is summed,
or mixed in to the main L/R MIX bus.
TO AUX 1
This routes the signal that is present on the AUX 2 RETURN
jacks to AUX 1 so that the effects can be heard in the monitor
mix.
POWER LED
The Power LED lights up to indicate that the main POWER
switch (located on the rear panel) is on.
Phantom Power LED
This LED illuminates indicating that the 48 volt phantom power
is applied to the microphone pre-amps enabling use with con-
denser microphones. The +48V LED will light up when the
Phantom Power switch (located on the rear panel) is switched
to the ON position.
Output Level Meter
The OUTPUT LEVEL METER allows you to monitor the level
of the signal which is being sent to the MIX OUT jacks.
NOTE:
To avoid distortion, adjust the Main Level control so that the 0
indicator LED lights occasionally.
9
Controls and Functions
MASTER SECTION (continued)
17
15
15
1718
16
18
16
19
19