Filter
Top Products
6
Quick Start
In order for your wireless system to work correctly, both the receiver and transmitter must be set to the same
channel.
FREQ:
518-546.9MHz
SR266 Receiver
Tested To Comply With
FCC Standards
For Home Or Oce Use
Set up the receiver:
Physically place the UR7 receiver where it will be used. The general rule of thumb is to maintain “line of sight”
between the receiver and transmitter so that the person using or wearing the transmitter can see the receiver.
Connect and position the antennas vertically.
Connect the included power adapter to an outlet.
Connect the UR7 receiver output jack to the microphone or line level input of a mixer or
amplifier using the balanced XLR output or unbalanced ¼” line level output.
Setting the receiver channel - When using a single system, set the receiver by using the Frequency Select menu.
When using multiple Synth 7 systems, use the Group & Channel menu so that each system should be assigned
to the same group in order to maximize the number of compatible channels
Single System Setup
Press and hold the power button to turn on the UR7 receiver. The receiver display will light.
Press the Menu/Select button to enter the Main Menu. Rotate the Menu/Select encoder to highlight
FREQUENCY SELECT and press the MENU/SELECT button.
Scroll down to highlight SCAN SPECTRUM and press the MENU/SELECT button. The receiver will scan the
wireless spectrum and choose an available channel.
Main Menu
Group & Channel
Frequency Setup
Audio Setup
Advanced Setup
Back
Frequency Select
518.000MHz
Scan Spectrum
IR Set
Back
Frequency Select
531.350MHz
Scan Spectrum
IR Set
Back
Scan Spectrum
531.350MHz
CH F05