Samson MTR101 Headphones User Manual


 
8
To isolate the MTR101 from external vibrations and prevent unwanted noises that
are transmitted through the stand, the microphone can be fitted on the custom-
designed MSM1 spider shockmount. Follow the steps below to install the micro-
phone into the shockmount.
Affix the shockmount onto a micro-
phone stand or boom arm. The
shockmount angle can be adjusted
by loosening the thumb screw near
the stand connection.
Note: Do not adjust the angle of
the shockmount without loosening
the thumb screw. If you do this, the
shockmount may be damaged and
you may void your warranty.
Install the MTR101 into the MSM1
by fitting the microphone into the
center of the web, positioning the
MTR101 onto the bottom mounting
plate with the Samson logo facing
forward.
Secure the MSM1 by rotating the
threaded collar clockwise until tight.
Loosen the thumb screw to adjust
the angle of the microphone and
position the MTR101 to the desired
location. Once set, tighten the
thumbscrew to secure the micro-
phone in place.
Note: Be careful not to cross-thread
or over-tighten the threaded collar or
thumb screw.
Shockmount (optional)