Samson CB88 Headphones User Manual


 
7
Concert 88 Camera System
ENGLISH
FRANÇAISDEUTSCHEESPAÑOLITALIANO
CB88 Belt Pack Transmitter - Callouts
1. Input Connector - Connect the input device via the
mini-XLR connector. The CB88 is supplied with a
lavalier microphone.
2. Status Indicator - This LED displays the operation mode:
GREEN Normal Operation
RED Mute
Flashing GREEN Low Battery
3. Power/Mute Switch - Press and hold to turn the unit
on or off. Press and release to mute or unmute the
transmitter.
4. Belt Clip - Use this clip to fasten the CB88 trans-
mitter to a belt or guitar strap.
5. Battery Cover Release - Push in both sides and pull
back to open the CB88 battery cover.
6. Antenna - This permanently attached transmitter
antenna should be fully extended during normal
operation.
7. Input GAIN Control - This control adjusts the trans-
mitter input sensitivity to work with microphone
and instruments inputs. For optimal performance,
using the included screwdriver, set the input GAIN
control to where you see the CR88V Audio Meter
maximum indicator start to light under high levels,
then turn down slowly until the maximum indicator
stops lighting.
8. Battery Holder - Insert two standard AA (LR6) bat-
teries here, being sure to observe the plus and
minus polarity markings shown. Although recharge-
able Ni-Cad batteries can be used, they do not
supply adequate current for more than four hours.
WARNING: Do not insert the batteries backwards;
doing so can cause severe damage to the CB88 and
will void your warranty.
9. IR Lens - This window is used to capture the infra-
red signal sent from the CR88V during the IR SET
to channelize the transmitter.
10. Plastic Screwdriver - Designed for use in adjusting
the CB88 input GAIN (#7) control.