Samson 88 Headphones User Manual


 
8
Charging the AH8 Transmitter
1. Snap in place the appropriate mains connector plug
into the adapter.
2. Insert the magnetic power cable to the included USB
AC plug (or any 5-volt DC adapter that has a USB
port). Insert the AC plug into an electrical outlet.
3. Place the AH8 transmitter on a flat surface.
4. Attach the magnetic connector to the gold contact
power port on the bottom of the AH8 transmitter.
The cable attaches to the port magnetically.
The magnetic connector is keyed so it will only
connect in one direction.
Note: Transmission is disabled during charging.
5. Look at the indicator light on the AH8 transmitter
to determine when the transmitter has finished
charging. When the light is flashing red, the AH8
is charging. When the red light stops flashing it
indicates that the AH8 is fully charged.
6. Disconnect the magnetic power cable from the AH8
when the unit is fully charged.
If you notice your AH8 battery life is becoming shorter
after a full charge, you can order a user replaceable
battery from your local Samson distributer.
Getting the most out of the rechargeable battery:
Completely charge the batteries before first use
Fully charge the battery before it will be used.
After the battery is charged, unplug the charger from the outlet or
remove the battery from the charger.
The optimal temperature range for using and storing the battery is
50°F - 86°F (30°C - 50°C). The battery performance and operation
may decrease in temperatures below 50°F (30°C).
A warning that batteries (battery pack or batteries installed) shall not be exposed to
excessive heat such as sunshine, fire or the like.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent type attention should be drawn to the environmental aspects of battery
disposal