Russound SP522.1 Speaker User Manual


 
TAKING CARE OF YOUR NEW CEILING SPEAKERS
RUSSOUND Ceiling Speakers are designed to last the life of your home if
you follow a few simple rules.
The main “killers” of any loudspeaker system are:
too little power at high volumes
too much power at high volumes
transients (immediate loud passages, thumps, etc.)
Too little power:
It’s a surprising fact but far more speakers are damaged by too little
power than by too much! When an amplifier runs out of power while
trying to re-create musical peaks, it causes a form of high frequency dis-
tortion called clipping. Clipping simply makes the music sound distort-
ed. In greater quantities over a period of time, it can damage or destroy
the tweeters (high frequency speakers) in any speaker system. If you like
your music LOUD, consider getting an amplifier with at least 50 watts
per channel.
Too much power:
There’s nothing wrong with driving your Russound speakers with as
much as 80 watts per channel—the extra power helps them achieve
quick musical transients found in digital recordings. However, you must
remember to restrain yourself and not get too heavy-handed with the
volume control (or remote buttons). If the music begins to sound dis-
torted or you hear a “clacking” sound during bass notes, back off! The
clacking is caused by the woofer’s voice coil trying to come out of its
socket.
Transients:
Loud, deep THUMPS, caused when your system is turned on/off, or when
the tonearm is dropped too hard on a record (if you still use those great
classics), can seriously damage any loudspeaker including your Russound
Ceiling models. Also remember to turn your system off before discon-
necting any hook-up cables. When they’re pulled out, a huge burst of
low frequency hum often occurs if the system is still on.
MORE ON SPEAKER WIRES AND AMPLIFIER IMPEDANCE
Not all amplifiers or receivers can safely operate two sets of speakers at
once. If you intend to use your Russound Ceiling Speakers at the same
time as your main speakers or if you intend to hook up two pairs of
speakers and use both at the same time, it’s important to consider both
the impedance of the speakers and the capabilities of the amplifier
you’re using. Russound makes a complete line of products from
Impedance-Matching Volume Controls to Impedance-Matching Speaker
Selectors. Ask you Russound dealer for details or simply write your
request for a line catalog to Russound or FAX us at 603.659.5388
First, consult the owner’s manual that came with the amp or receiver. It
should tell you the minimum speaker impedance during simultaneous
operation. On some models the manual will recommend that only two
pairs of 8-ohm speakers be used at the same time. Others might allow
one set of 8-ohm speakers and one set of 4-ohm impedance speakers.
A few extremely powerful receivers and power amplifiers may even
allow two sets of 4-ohm speakers.
If you can’t readily determine this information, consult the dealer where
you purchased the amplifier, or call the manufacturer of the product in
question. Next, determine the impedance of your other speakers. It’s
often printed on the back of the enclosure near the connection termi-
nals, or you can consult the speaker’s owners manual.
If your other speakers are rated at 4-ohms, some amplifiers may experi-
ence difficulty driving both 4-ohm sets at once and shut off intermit-
tently when the volume control is turned up. In this case, you should
operate only one set of speakers at a time or keep the volume extremely
low.
Another option is to purchase a speaker selector such as the Russound
SS4 & SS6 series or a PRO series speaker selector. These are designed to
maintain impedance control allowing your amplifier to work efficiently.
8