Russound SP522.1 Speaker User Manual


 
3
OTHER ACOUSTIC CONSIDERATIONS
For best fidelity, there are several other factors to keep in mind before
you start actual installation.
Concerns and reflections:
When a ceiling speaker is placed close to the comer of a room, bass fre-
quencies are emphasized. This can be okay if both speakers are mount-
ed near corner (while maintaining stereo imaging), but try to avoid plac-
ing just one speaker in a corner and another on a long flat surface.
In general, the best acoustic performance will result if both speakers
face a similar type of surface and are placed in similar positions on the
same type of wall or ceiling.
Installation Depth:
Russound Ceiling speaker models SP503.1, SP522.1 and SP523.1 require
at least 3” of wall depth (measured from the outside surface of the
wall). This means that they can be installed in any wallboard between
ceiling joists or a 2x4 stud wall. In fact, the dense, rigid nature of plas-
terboard or (lath and plaster in older homes) acts as a superb speaker
baffle.
When installing the speakers, avoid:
T-bar “drop ceilings” with very thin fiberboard panels which can buzz
and vibrate. If you suspect this will happen, reinforce the drop-in
panel with wood or particle board.
Any wall which can’t provide proper depth (clearance) for the back of
the Russound speaker. This includes brick or concrete walls where
the wallboard or paneling is attached to thin furring strips.
Inside wall space less than 10” wide and 24” in height
Ceilings and walls where you know that there are pipes, heating
ducts and ESPECIALLY AC wiring in the general vicinity. For example,
if there is an outlet along the baseboard, there is often a live wire
running partly up the wall at that point. The same applies for ceiling
fans, overhead lighting, etc.
DUAL VOICE COIL
Dual voice coil speakers are used to create a stereo sound from one
speaker. The left and right inputs are both connected to the two differ-
ent inputs at the speaker. The action of two voice coils on one cone
simulates a full range mono signal.
4
5
2
33
2
4
11
GOOD
for stereo imaging
EXCELLENT
for stereo
imaging
FINE for
background
music;
ACCEPTABLE
for stereo
effect
Figure1 Russound ceiling mount speakers may be used for rear surround sound channels by placing them (1) behind, (2) on each side of the viewing
position or (3) in the ceiling just behind the viewers. The available SP550.2 & SP650.1 speakers also make excellent, unobtrusive front channel home
theater speakers for 5 channel listening.
Figure 2
Dual Voice Coil
Speaker Placement