Russound CAV6.6 Six-Zone Stereo Amplifier User Manual


 
52
INSTALLER
INSTALLATION MENU
Key Config (cont’d.)
2. SOURCE NUM Select the source the key will be configured for.
(Src #)
3. SELECT A KEY Using or , select the keypad key to be configured.
(SelKy)
4. KEY TYPE Either “Key Press,” “Key Hold” or “Both” will activate the command.
(KeyTp)
5. KEY NAME Name that appears on the keypad display when the command is
(KeyNm) activated.
6. COMMAND TYPE Select the type of source command (e.g., CD, TV, etc.).
(CmdTp)
a. Selected: Learned IR Choose Learned IR if the pre-programmed IR code library does
(LrnIR) not support the source component.
i. LEARNED SRC – Select the learned source bank to be assigned to the source
(LnSrc) component. Procedure advances to KEY FUNCTION (step 8)
b. Selected: Unassigned The key configuration is cleared. Procedure advances to SAVE
(Unasg) CHANGES (step 9)
c. Selected: Default Default selects the same device type and device code previously
(Deflt) setup in BASIC SETUP. Procedure advances to KEY FUNCTION
(step 8)
d. Selected: Macro: (To build macros, see Macro Editor page 60)
i. MACRO - Macro loads a series of commands which are processed when
(Macro) activated.
ii. MACRO ID Enter the macro ID number. Menu advances to SAVE CHANGES
(MacID) (step 9)
e. All Other Selections: Procedure advances to DEVICE CODE (step 7)
7. DEVICE CODE Enter source component code number listed in this manual’s
(DevCd) Reference section.
8. KEY FUNCTION Select a function for the button.
(KeyFn)
9. SAVE CHANGES? Select “yes” to save changes. Procedure advances to ZONE NUM
(Save?) (step 1)