Filter
Top Products
This manual includes items that are designed to assist in the programming process.
Sample Configurations (Pages 80-91)
A series of sample configurations are provided to showcase a variety of system designs and compo-
nent options.
Forms (pages 46-48)
Three blank reproducible forms are included as planning tools when determining sources, settings
and zone preferences. The Source and Zone Information forms and the Macro Editor form should be
completed before programming and referred to during the installation menu process. This speeds up
programming time and reduces missed or incorrect entries. These forms also serve as system refer-
ence documents if future troubleshooting is needed.
IR Device Codes (Pages 74-77)
This list of command type IR device codes reflects the built-in IR codes in the CAV6.6 library. During
programming, these codes will be entered for each source at the “Device Code” prompt. If a code is
not listed for a source, the Learn IR procedure is available to learn in and centrally store IR codes.
Key Functions (Pages 92-113)
This list of key functions identifies what IR codes are supported for each command type (source) by
the built-in library. “Learned Only” indicates that this function is not supported and must be learned
into the CAV6.6. This list of key functions reflects the different available key functions associated with
what you see on the LCD panel when performing the Key Configuration procedure in the Installation
Menu. The list of functions corresponds with the command types above (e.g., Tuner, CD player, etc.).
Source Names (Pages 78-79)
A list of assignable Source Names is provided for advance selection and source form completion
before programming.
Flow Charts (Pages 62-72)
Installation Menu flow charts provide a graphical representation of the programming process.
Installation Menu (Pages 49-61)
The Installation Menu provides the step-by-step complete programming procedure for the keypad and
the controller.
Although you can begin programming at any point within the Installation Menu, the following sequence
is recommended for initial installations, as it progresses from the most basic requirements to the
more advanced features.
1. Controller Setup (CTRLR SETUP) (Page 57)
This procedure sets the controller ID number within the system. This number must be manually set
when multiple CAV6.6’s are linked through RNET within one system. This procedure is not necessary
for systems with only one CAV6.6.
(continued)
INSTALLER
PROGRAMMING
System Programming Overview
44