Filter
Top Products
42
The CAV6.6 can be programmed via keypad
connection using CAT-5 and the T568A RJ-45
wire configuration. An UNO-S2 Keypad can be
attached to the controller at the Programming
Center Keypad Port Connection.
The Programming Center Keypad Port is
designed for use in local programming, specifi-
cally for learning IR commands directly into the
IR receiver on the controller’s front panel.
(see
Learn IR flow chart on page 70)
.
The CAV6.6 can also be programmed from any
UNO-S2 keypad connected to its keypad ports.
INSTALLER
MAKING CONNECTIONS
Programming Center Keypad Port Connection