Filter
Top Products
5
TOOLS NEEDED
The following information will indicate some tools and
materials necessary for a complete installation:
•4 twisted pair communication wire (commonly referred to
as CAT-5). This wire will be used to connect the keypads
in each zone to the controller. 16 Gauge minimum, 2
conductor CL3 rated wire. (Russound AW162CL3) This
wire is used for direct connection between the CA and
your speakers.
•110 Punchdown tool (included)
•A small jewelers flat-head screwdriver (included)
•A medium sized flat-head screwdriver.
•Wire strippers and cutters
•Electric drill and a 1/2" x 6" drill bit
•A steel-wire fish tape
•A keyhole saw
•Electrical junction boxes (6)
•A stud finder
•A screwdriver (cordless recommended)
•Misc. hand tools, nails & screws
•Cable staples
If you have problems or you are not absolutely comfortable
with what you are doing, consult a professional carpenter,
electrician, or system installer.
BASIC PLANNING AND LAYOUT CONSIDERATIONS
•Where will the speakers be located?
•Where will the keypads be located?
•How will the wiring be routed to each location?
•Where is the source equipment located?
•Where is the CA controller going to be located?
CONNECTION TIPS
•Disconnect all power cords before connecting to the CA.
•Verify that all connections and polarity are correct.
•Keep all power cords away from all signal cables to pre-
vent noise or humming.
•Choose reliable signal cables / patch cords.
•Label all wires with room location at both ends of the
wire.
•Take your time!!! Don't panic about the number of wires;
simply connect one at a time.
GETTING STARTED
Speaker Wire Length Gauge of Speaker Wire
10-100 feet 16 AWG
100-150 feet 14 AWG
Over 150 feet 12 AWG
Keypad Control Max Recommended
Wire Type Wire Length
CAT-5 100 feet
Russound MCW2418 200 feet
CA-Series manual R6 10/17/01 1:50 PM Page 5