Filter
Top Products
Operation
Runco LS-3/LS-5 Installation/Operation Manual 61
PRE
L
IMINAR
Y
ControlSelect Control from the Main Menu to set various options related to control of the
projector.
1 Key / 2 Key / 3 Key / 4 Key / 5 Key: These menu items assign the function of the
keys numbered 1 through 5 on the remote.
There are eight sources corresponding to the eight connections to the projector. When
you assign a source to a numbered key, the projector immediately goes to that source
when the key assigned to it is pressed.
If the chosen source is disabled via the Source Enable menu (refer to page 4.-58), this
setting has no effect.
M1 Key / M2 Key / M3 Key: These menu items assign which memory setting to recall
when the M1, M2 or M3 key on the remote is pressed.
Trigger 1: Select Trigger 1 from the Control menu to specify when the Trigger 1 port
outputs 12 volts. There is a three-second delay before activation to prevent operation
while selecting an aspect ratio.
• Lamp causes the port to output 12 volts whenever the lamp is on.
• 16:9 causes the port to output 12 volts whenever the 16:9 aspect ratio is chosen.
• Letterbox causes the port to output 12 volts whenever the Letterbox aspect ratio is
chosen. The output stops if PIP is enabled (PIP source is set to anything other than off).
• 4:3 causes the port to output 12 volts whenever the 4:3 aspect ratio is chosen. The
output stops if PIP is enabled (PIP source is set to anything other than off).
• 4:3 Narrow causes the port to output 12 volts whenever the 4:3 Narrow aspect ratio is
chosen. The output stops if PIP is enabled (that is, the PIP source is set to anything
other than off).