Filter
Top Products
Installation
Runco LS-3/LS-5 Installation/Operation Manual 23
PRE
L
IMINAR
Y
3.5
Mounting the
LS-3/LS-5
There are several methods for mounting the projector. Depending on your chosen
installation, one method may be more suitable than another.
Floor Mounting (Upright)In typical front and rear screen installations, the projector can be mounted to a secure and
level surface such as a table or cart. Carts are useful when moving a projector during a
presentation or from site to site. If possible, lock the wheels when it’s in position to prevent
it from being moved during a presentation.
Ceiling Mounting
(Inverted)
For fixed installations, and for those that want the projector out of sight or have a limited
space for projector and audience, you can invert the LS-3/LS-5 and suspend it from the
ceiling using a specially-designed ceiling mount fixture.
Adjusting the Projection
Angle
If the screen is significantly higher or lower than the projector, you can also tilt the
projector at a slight angle. In a ceiling installation, you do this by adjusting the ceiling
mount.
For a floor installation, turn the adjustable feet at the bottom of the projector to adjust the
projection angle.
If you do this, you may need to vertically shift the image to compensate. For detailed
instructions, refer to
Lens Adjustments on page 31.
For ceiling installations, use Runco-approved mounting hardware
and M4 screws with a maximum screw depth of 10
mm (0.39 inch).
Install the mount kit according to the instructions provided with it.
Note