Filter
Top Products
10
About Placement
If you want to mount the S-OPT in a rack, make sure to use only the BOSS RAD-50 Rack Mount Adaptor (sold
separately). To install, secure the S-OPT to the RAD-50 with three screws, one is screw supplied with the RAD-
50 and another two screws are supplied with the S-OPT.
If using commercially available Cat5e Ethernet cables, attach the supplied REAC connector cover to the connector.
Attach the rubber feet when not rack mounting the unit.
Peel off the backing from the double-sided adhesive tape on the rubber feet and attach the feet at the points
indicated in the figure below.
Using the Unit While Mounted in a Rack
Using the REAC Connector Cover
Attaching the Rubber Feet
When turning the S-OPT upside down, place stacks of newspapers or magazines to support the
four corners (or two sides) so that stress is not placed on the S-OPT itself. Also, handle the S-OPT
with care, and avoid dropping it.
RAD-50
S-OPT
* Remove the REAC connector covers if you are using REAC
cables with EtherCon type connectors (the REAC cable which
comes with the S-OPT or SC-W100S). Take care not to lose
the REAC connector covers removed at this time.
bottom of the unit