Filter
Top Products
– 1 –
Introduction
Rockford engineers designed the Power series amplifiers to withstand the
rugged automotive environment while delivering superior sound quality in
a flexible, reliable, and efficient package. TRANS•ana is a low voltage cir-
cuit in the preamp stage lets the music sound crystal clear and very real,
even when played at high volume levels. This is matched with TOPAZ, a
unique grounding circuit used to eliminate noise problems associated with
car audio systems and their installation. Flexibility is accomplished with the
use of a built-in variable crossover. The use of a protection circuit called
NOMAD, along with MOSFET and DSM (Discrete Surface Mount) technol-
ogies improve amplifier efficiency. The result of these components give the
Power amplifier awesome sound quality in a “Bullet Proof” package.
Explanations of these technologies, most of which are exclusively designed
and patented by Rockford, are described in the Technical Design Features.
Power Amplifier Accessory Pack
The accessory pack shipped with the Power amplifiers includes the mount-
ing hardware necessary to secure the amp to the vehicle.
Installation & Operation Manual
Punch Verification Certificate
(4) Amplifier mounting screws (#8 x 3/4" Phillips)
(4) Speaker/Power connector set screws (3/32" Allen)
(4) Endbell mounting screws (9/64" Allen)
(1) Allen wrench (3/32")
(1) Allen wrench (9/64")
(1) Inline fuseholder (Power 250, Power 360 & Power 400 amps)
(1) AGU 30 amp fuse (Power 250 2-channel amp)
(1) AGU 40 amp fuse (Power 360 2-channel amp)
(1) AGU 50 amp fuse (Power 400 4-channel & Power 600 5-channel amps)
(1) Remote Punch Bass (replacement part #WP-2429)
(1) 15' Remote Punch Bass cable (replacement part #CC-2421)
(2) Remote Punch Bass bracket screws (4 x 7/16" Phillips)
NOTE: Refer to the specifications section for recommended fuse sizes on
the Power 800 2-channel, Power 800 4-channel & Power 1000 2-channel
amps.