14
SPECIFICATIONS
Specifications subject to change without notice
MODEL- PUNCH 150S 200S 300S
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts
4Ω Load Per Channel 37.5 Watts x 2 50 Watts x 2 75 Watts x 2
2Ω Load Per Channel 75 Watts x 2 100 Watts x 2 150 Watts x 2
4Ω Load Bridged (Mono) 1500 Watts x 1 200 Watts x 1 300 Watts x 1
Dimensions: (with Endbell)
Height 2.4" (6.1cm) 2.4" (6.1cm) 2.4" (6.1cm)
Width 9.8" (24.89cm) 9.8" (24.89cm) 9.8" (24.89cm)
Length 10.35" (26.42cm) 10.35" (26.42cm) 11.35" (28.96cm)
Battery Fuse Rating (Amp) 20A 20A 30A
(External to Amplifier)
Fuse Type ATC ATC ATC
MODEL- PUNCH 400S 500S 700S
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts
4Ω Load Per Channel 100 Watts x 2 125 Watts x 2 175 Watts x 2
2Ω Load Per Channel 200 Watts x 2 250 Watts x 2 350 Watts x 2
4Ω Load Bridged (Mono) 400 Watts x 1 500 Watts x 1 700 Watts x 1
Dimensions: (with Endbell)
Height 2.4" (6.1cm) 2.4" (6.1cm) 2.4" (6.1cm)
Width 9.8" (24.89cm) 9.8" (24.89cm) 9.8" (24.89cm)
Length 12.35" (31.42cm) 13.35" (33.96cm) 18.35" (46.74cm)
Battery Fuse Rating (Amp) 40A 50A 60A
(External to Amplifier) Not Supplied
Fuse Type ATC AGU AGU
Signal-to-Noise Ratio >100dB A-weighted
Crossover Slope 12dB/octave Butterworth
Crossover Frequency (Models 150S & 200S) Fixed 80Hz LP, AP, 120Hz HP
Crossover Frequency (All Other Models) variable from 50Hz to 210Hz
Frequency Response 20Hz to 20kHz ±0.5dB
Bandwidth 20Hz to 200kHz ±3dB
Damping Factor @ 4Ω (at output connector ) >200
Slew Rate 30 Volts/ms
IM Distortion (IHF) <0.05%
Acceptable Signal Voltage Range Variable from 250mV to 6V (RCA Input)
Variable from 0.5V to 11V (High Level Input)
Protection NOMAD - Internal analog-computer output protection
circuitry limits power in case of overload. Thermal
switch shuts down the amplifier in case of overheating.
Equalization (45Hz Punch Bass) (Models 150S & 200S) Switchable from 0dB to +6dB to +12dB
Equalization (45Hz Punch Bass) (All Other Models) Variable from 0dB to +18dB @ 45Hz
Input Impedance 20k ohms